Investigation of the morphology of YBCO deposited and grown on SrTiO₃

Authors

Norman S. Vitancol ⋅ PH Materials Science and Engineering Program, University of the Philippines Diliman
Maricon R. Amada ⋅ PH Materials Science and Engineering Program, University of the Philippines Diliman
Gwendolyne B. Pascua ⋅ PH National Institute of Physics, University of the Philippines Diliman
Adrel Voltaire A. Cueto ⋅ PH National Institute of Physics, University of the Philippines Diliman
Roland V. Sarmago ⋅ PH National Institute of Physics, University of the Philippines Diliman

Abstract

In this study, the morphology of YBCO deposited and grown on SrTiO₃ by combined physical deposition and thermal annealing was observed via scanning electron microscope. The effects of time and temperature conditions in the annealing process of the samples affect the morphology of the film. Samples annealed at 980°C for 1 hour then at 940°C for 30 hours exhibited smoother surface morphology.

Downloads

Issue

2003: Proceedings of the 21st Samahang Pisika ng Pilipinas Physics Congress

Creating essential bridges uniting physics, society and industry
22-25 October 2003, University of San Carlos, Cebu City

Article ID

SPP-2003-PB-30

Section

Poster Session PB

Published

2003-10-22

How to Cite

[1]

NS Vitancol, MR Amada, GB Pascua, AVA Cueto, and RV Sarmago, Investigation of the morphology of YBCO deposited and grown on SrTiO3, Proceedings of the Samahang Pisika ng Pilipinas 21, SPP-2003-PB-30 (2003). URL: https://proceedings.spp-online.org/article/view/SPP-2003-PB-30.